The Effect Of Minimal Quantity Lubrication (MQL) On The Surface Roughness Of Titanium Alloy Ti-6Al-4V ELI In Turning Process

Che Haron, Che Hassan and A Ghani, Jaharah and Sulaiman, Mohd Amri and Lutfiah Intan and Kasim, Mohd Shahir (2011) The Effect Of Minimal Quantity Lubrication (MQL) On The Surface Roughness Of Titanium Alloy Ti-6Al-4V ELI In Turning Process. Advanced Materials Research Journal, 146-14 (1750). pp. 1750-1753. ISSN 10.4028

[img] PDF
2_The_effect_of_mql_on_surface_roughness_of_titanium_alloys_Ti6Al4V_ELI_in_turning_process.pdf - Submitted Version
Restricted to Registered users only

Download (271kB) | Request a copy

Abstract

This paper investigates the effect of minimum quantity lubricant (MQL) on the surface roughness of titanium alloy Ti-6Al-4V ELI when turning using uncoated tungsten carbide tool. The response surface method (RSM) design of experiment using Box-behnken was used to accomodate the turning experiment factors and levels. Turning parameters studied were cutting speed (100, 135, 170 m/min), feed rate (0.15, 0.2, 0.25 mm/rev) and depth of cut (0.6, 0.8, 1.0 mm). The results show that the feed rate was the most influence factor controlling the surface roughness produced. The feed rate (F) was found directly proportional with the surface roughness value (Ra) but inversely proportional to the cutting speed (Vc). MINITAB software was used to develop a surface roughness model, and the optimum condition was at 160 m/min of cutting speed, 0.18 mm/rev of feed rate and 1 mm of depth of cut. At the optimum condition low value of 1.54 µm surface roughness was obtained.

Item Type: Article
Uncontrolled Keywords: Titanium, High speed turning, Carbide tool
Divisions: Faculty of Manufacturing Engineering > Department of Manufacturing Process
Depositing User: En. Mohd Amri Sulaiman
Date Deposited: 05 Feb 2014 08:25
Last Modified: 23 Jun 2021 15:21
URI: http://eprints.utem.edu.my/id/eprint/9105
Statistic Details: View Download Statistic

Actions (login required)

View Item View Item