Browse By Repository:

 
 
 
   

Effect Of Tool Geometry, Material Hardness And Cutting Parameters On The Cutting Force Turning Process

Mohamad Saiful Azhar, Harun (2005) Effect Of Tool Geometry, Material Hardness And Cutting Parameters On The Cutting Force Turning Process. Project Report. UTeM, Melaka, Malaysia. (Submitted)

[img] PDF (24 Pages)
Effect_Of_Tool_Geometry,_Material_Hardness_And_Cutting_Parameters_On_The_Cutting_Force_Turning_Process.pdf - Submitted Version

Download (2714Kb)
[img] PDF (Full Text)
Effect_Of_Tool_Geometry,_Material_Hardness_And_Cutting_Parameters_On_The_Cutting_Force_Turning_Process.pdf - Submitted Version
Restricted to Registered users only

Download (13Mb)

Abstract

In this experiment, effect of tool geometries, material hardness, feed rate, and cutting speed on cutting forces were experimentally investigated. High speed steel (HSS) tool blank with three type of geometries was prepared and mild steel CF1018 and DF2 steel bars were used as workpiece. Effect of tool geometries material hardness and cutting parameters on cutting forces statistical analysis of variance was performance. During the experiments two component of tool of tool force and tool life of cutting tool were measured. This experiment shows that the effect of tool wear was influenced to increase the cutting force. Different of tool geometries were showed the variance was performance on cutting force. Where sharp edge show lower tangential force on CF1018. The contact between lmm radius (nose radius) and workpiece had been small impact on cutting force. But honed radius always high tangential force on CFl 018 remarkably influence to material hardness also cutting force. However material hardness is a one of the factors of increased cutting force and tool life. Therefore, the resulted obtained from the analysis technique indicated that the longer the cutting tools were in contact with the workpiece, the higher the rate of wear. The Taylor's equation derived from the experiment is VT0· 15 = 4.78.

Item Type: Monograph (Project Report)
Uncontrolled Keywords: Metal-cutting tools, Metal-work, High-speed machining
Subjects: T Technology > T Technology (General)
T Technology > TJ Mechanical engineering and machinery
Divisions: Library > Projek Sarjana Muda > FKM
Depositing User: Jefridzain Jaafar
Date Deposited: 10 Sep 2013 07:40
Last Modified: 28 May 2015 04:06
URI: http://eprints.utem.edu.my/id/eprint/9721

Actions (login required)

View Item View Item

Downloads

Downloads per month over past year