Effect of high-speed parameters on uncoated carbide tool in finish turning Titanium Ti-6Al-4V ELI

Sulaiman, Mohd Amri and Kasim, Mohd Shahir (2014) Effect of high-speed parameters on uncoated carbide tool in finish turning Titanium Ti-6Al-4V ELI. Sains Malaysiana, 43. pp. 111-116. ISSN 0126-6039

This is the latest version of this item.

[img] PDF
M.A._Sulaiman.pdf - Published Version
Restricted to Registered users only
Download (1MB)
Official URL: http://www.ukm.my/jsm

Abstract

In this work, the Sandvik uncoated carbide insert, CNGG 120408-SGF-H13A was used as a cutting tool in high-speed turning of titanium alloy Ti-6Al-4V ELI (extra-low interstitial) with hardness of 32 HRC. Wear is one of the problems that cannot be avoided in machining process. Therefore, the objective of this paper was to investigate tool-wear behavior of various cutting-speed values (high-speed range) on the tool life of the cutting tools, especially in finishing titanium alloy. The experiments were performed under flooded coolant condition using water-based mineral-oil. The cutting speeds employed were 120, 170 and 220 m/min. The feed rate was constant at 0.2 mm/rev and the depth of cut was 0.4 mm. Based on the results, the highest cutting speed of 220 m/min caused the highest wear rate. By linking the machine operations and the tool life curves obtained using flank wear data, the wear behavior of uncoated carbide was described.

Item Type: Article
Uncontrolled Keywords: uncoated carbide tool
Subjects: T Technology > TJ Mechanical engineering and machinery
Divisions: Faculty of Manufacturing Engineering > Department of Manufacturing Process
Depositing User: En. Mohd Amri Sulaiman
Date Deposited: 28 Jul 2015 07:39
Last Modified: 28 Jul 2015 07:39
URI: http://eprints.utem.edu.my/id/eprint/14781
Statistic Details: View Download Statistic

Available Versions of this Item

Actions (login required)

View Item View Item