Abdullah, Muhammad Ilman Hakimi Chua and Mohamad Norani, Mohamad Nordin and Abdollah, Mohd Fadzli bin and Amiruddin, Hilmi and Ramli, Faiz Redza and Tamaldin, Noreffendy (2020) Tribological Analysis Of A 3D-Printed Internal Triangular Flip ABS Pin During Running-In Stage. Jurnal Tribologi, 27. pp. 42-56. ISSN 2289-7232
Text
JT-27-42-56.PDF Download (721kB) |
Abstract
The objective of this study was to investigate the correlation between the coefficient of friction (COF) and the running-in distance as well as the wear properties of acrylonitrile butadiene styrene (ABS) polymer. This was achieved by comparing a 3D-printed internal triangular flip ABS pin with a 3D-printed solid ABS pin under varying loads and sliding speeds. The ABS pin that was investigated was modified into a triangular flip internal structure and manufactured via 3D printing through fused filament fabrication (FFF). The experiment was conducted under dry conditions using a pin-on-disc tribometer. At a load of 58.68 N and sliding speed of 600 rpm, the runningin distance of 145.16 m showed that the triangular flip ABS pin produced a lower steady-state COF (0.305) compared to the solid ABS pin. The triangular flip ABS pin exhibited the effects of an early contact microstructure as well as changes in the surface area composition that resulted in a low maximum stress, thereby decreasing the COF. A morphological analysis using scanning electron microscopy (SEM) revealed that delamination and abrasion were the main mechanisms of wear
Item Type: | Article |
---|---|
Uncontrolled Keywords: | 3D Printing, Tribology, ABS, Running-In, COF |
Divisions: | Faculty of Mechanical and Manufacturing Engineering Technology > Department of Manufacturing Engineering Technology |
Depositing User: | Norfaradilla Idayu Ab. Ghafar |
Date Deposited: | 27 Apr 2021 15:30 |
Last Modified: | 27 Apr 2021 15:30 |
URI: | http://eprints.utem.edu.my/id/eprint/25047 |
Statistic Details: | View Download Statistic |
Actions (login required)
View Item |